Subaru Impreza II 2 GD owners manual page 123

text version of content this owner's manual page from owners manual to the vehicle Subaru Impreza, year of production 2001 - 2007:

A1900BE-A.book Page 10 Friday, June 17, 2005 5:40 PM 3-10 Instruments and controls Setting the alarm-level en- or longer: Speed setting changes down-3. Activate or deactivate the buzzer as gine speed ward by 1,000 rpm. desired using the REV setting knob. y Clockwise (+) for 0.5 second or long- y Turn the knob clockwise (+) to acti- er: Speed setting changes upward byvate the buzzer. The indicator will show 1,000 rpm. “ON”, and the buzzer will sound three The speed setting will stop changing if ittimes. With the buzzer activated, en- reaches 0 rpm or the maximum engine gine-speed warnings are given by both speed. the REV indicator light and the buzzer. y Turn the knob count erclockwise (–) to The alarm-level engine speed can be set deactivate the buzzer. The indicator will show “– –”, and the buzzer will not (in 100 rpm steps) within a range from 2,000 to 7,500 rpm. sound. With the buzzer deactivated, en- The indicator shows the setting as follows:gine-speed warnings are given only by the REV indicator light. 300618 Speed (rpm) Indication Approximately three seconds after you stop turning the knob, the buzzer will 1. Turn the REV setting knob clockwise or sound once to indicate the end of the set- counterclockwise, then release it and let it 000 ting procedure. The indicator will return to return to its initial position. The buzzer will2,000 20 showing the outside temperature. sound. The REV alarm system is now Also, the tachometer needle will return to ready to be set. 2,100 21 approximately “0”. 2. Turn the REV setting knob to select the ∼∼ desired alarm-level engine speed. NOTE At this time, the outside temperature indi- 7,400 74 y The REV alarm system does not op- cator will show the engine-speed setting. erate while settings are being entered. y Counterclockwise (–) for less than 0.5 7,500 75 y The speed-setting mode terminates second: Speed setting changes down- if 0 rpm is selected. ward by 100 rpm. y The speed-setting mode is canceled Approximately three seconds after you y Clockwise (+) for less than 0.5 sec- if the ignition switch is turned to OFF or stop turning the knob, the REV alarm sys-the vehicle starts moving before the ond: Speed setting changes upward by tem will automatically enter its next setting 100 rpm. mode (step 3 below), in which you can ac-setting procedure is finished. y Counterclockwise (–) for 0.5 second tivate or deactivate the buzzer. y Speed setting is impossible when

owners manual Subaru Impreza

owners manual Subaru Impreza - year of production: 2001, 2002, 2003, 2004, 2005, 2006, 2007 - Subaru Impreza II 2 GD owners manual EN