owners manual VW Transporter T4

owners manual VW Transporter T4 - year of production: 1990, 1991, 1992, 1993, 1994, 1995, 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003 - VW Transporter T4 Westfalia oweners manual EN

Document: pdf (25.83 MB) 164 pages

all ratings: 0 average rating: 5

text version of content this owner's manual page from owners manual to the vehicle VW Transporter T4, year of production 1990 - 2003:

DO-IT-YOURSELF zyxwvutsrqponmlkjihgfedcbaZYXWVUTSRQPONMLKJIHGFEDCBA If it has been established when changing Lift vehicle until the defective wheel is clear of ground. the wheel that wheel bolts are corroded and hard to screw in, they must be renewed be- Remove wheel bolts and place them on fore checking the tightening torque. a clean surface (hub cap, cloth, paper) next Until these checks have been carried out to the jack and take the wheel off. one should, for safety reasons, only drive at Fit spare wheel and lightly tighten all a moderate speed. bolts. The wheel bolts must be clean and easy to turn - do not under any circum- stances use grease or oil! The defective wheel should be repaired as soon as possible. Lowervehicleand fully tighten bolts indi- agonal sequence. Attention Refit the wheel trim. If the vehicle is to be subsequent- ly fitted with wheels or tyres Place defective wheel in spare wheel which differ from those fitted by carrier and secure it - see page 119. - Wind jack arm up by turning the crank the factory, it is essential to read Notes the remarks in the centre and handle until the jack just goes under the right hand columns on page 113. zyxwvutsrqponmlkjihgfedcbaZYXWVUTSRQPONMLKJIHGFEDCBA vehicle. Pay attention to the following after changing a wheel: - The claw of the jack must fit round the - Check the tyre pressure immediately on vertical rib on the side member so that the spare wheel which has been fitted. the jack cannot slip when vehicle is lifted - see illustration. - Have the tightening torque of the wheel bolts checked with a torque wrench as - If the ground is soft, place a large strong soon as possible. The torque for steel piece of packing under the jack base plate. and alloy wheels is 160 Nm. - Align jack and at same time wind claw up further until it contacts the vertical rib on side member. www.WestfaliaT4.info - a useful website for owners and enthusiasts of VW Westfalia T4 Transporter / Eurovan Campervans 121

Download PDF

Click here to download a pdf file with an instruction manual for VW Transporter T4
year of production from: 1990

Do you prefer pdf format?
Find out how to download

Enter the code to download PDF file:

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.