owners manual Suzuki Swift

all ratings: 0 average rating: 5

OPERATING YOUR VEHICLE Starting a Cold and Warm Engine (For Diesel Engine Model) Caution when stopping the engine with (For Gasoline Engine Model) Cold engine turbocharger With your foot off the accelerator pedal, Press the engine switch to change the igni-When stopping the engine after climbing or crank the engine by pressing the engine tion mode to "ON" and wait until the glow high speed driving, let the engine idle for switch to change the ignition mode to plug indicator goes out if it comes on. about one minute or more (if it is not pro- "START". Crank the engine by pressing the engine hibited) to cool down the turbocharger and switch to change the ignition mode to engine oil. This is to prevent the engine oil NOTICE "START". from over-deteriorating. Deteriorated Do not crank the engine for more engine oil will damage the bearings of the than 12 seconds at a time. NOTICE turbocharger. If the engine doesn't start on the first Do not crank the engine for more Restarting diesel engine after fuel- try, wait about 15 seconds before try-than 12 seconds at a time. empty stop ing again. If the engine doesn't start on the first The engine stops and the malfunction indi- After pressing the engine switch to change try, wait about 15 seconds before try-cator light comes on if the engine feels fuel the ignition mode to "START", the starter ing again. emptiness. To restart the engine, stop the cranks the engine for about 12 seconds vehicles, hold the ignition key in "ON" posi- before it can start the engine. If the engine Warm engine tion or press the engine switch to change fails to start at the first attempt, wait about Crank the engine by pressing the engine the ignition mode to "ON" for 5-10 seconds 15 seconds, then try again while keeping switch to change the ignition mode to to feed fuel, then perform above engine the engine switch pressed while pressing "START". starting procedure. Have the indicator light down the accelerator pedal to 1/3 of its turned off by your SUZUKI dealer. travel. Release the accelerator pedal when If the "PUSH" indicator light blinks the engine starts. and the engine cannot be started If the engine still does not start, try holding Your keyless push start system remote the accelerator pedal all the way to the controller may not be sensed as being floor while cranking. This should clear the within the "interior workable area". Try is flooded. again after making sure that you have the engine if it remote controller with you. If the engine If you are unable to start the engine using still cannot be started, the battery of the this procedure, consult your SUZUKI remote controller may be discharged. You dealer. must then use the following method to be able to start the engine. 3-15

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders