owners manual Ford Mustang

all ratings: 0 average rating: 5

Universal Garage Door Opener (If Equipped) 3. Hold the transmitter within 1–3 inches (2–8 centimeters) of the button on the visor you want to program. 4. Press and hold both the programmed Genie button on the hand-held transmitter and the button you want to program. The indicator light on the visor flashes rapidly when the programming is successful. Note:The Genie transmitter transmits for up to 30 seconds. If HomeLink does not program within 30 seconds, then you need E142662 to press the Genie transmitter again. If the 1. Press and hold the program button on Genie transmitter indicator light displays the garage door opener motor until green and red, release the button until the both blue indicator lights turn on. indicator light turns off before pressing the 2. Release the program button. Only the button again. smaller, round indicator light should be When you program HomeLink successfully, on. you need to take the Genie transmitter out 3. Press and release the program button. of program mode. To do this: The larger purple indicator light flashes. 1. Press and hold the previously Note:You must complete the next two programmed Genie button on the steps within 30 seconds. hand-held transmitter for 10 seconds. 4. Press and release the Genie Intellicode The indicator light change from a 2 hand-held transmitter’s previously steady red light to a red and green light. programmed button. Both indicator 2. Press the same button twice to confirm lights on the garage door opener motor the change. When the indicator light unit should now flash purple. turns green, you know you took your 5. Press and hold the previously Genie transmitter out of program programmed button on the visor for 2 mode. seconds. Repeat this step up to 3 times Programming HomeLink to the Genie until the garage door moves. Intellicode Garage Door Opener Motor Programming is now complete. Note:You may need a ladder to access the Clearing a HomeLink Device garage door opener motor. To erase programming from the three HomeLink buttons, press and hold the two outer HomeLink buttons until the indicator light begins to flash. When the indicator light begins flashing in 10 to 20 seconds. release both buttons. You erased the programming. The indicator light should blink slowly to indicate the device is in train mode after you press any of the three HomeLink buttons. 117 Mustang (), enUSA, First Printing

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders