owners manual Volvo S60

all ratings: 0 average rating: 5

03 Your driving environment ® HomeLink Wireless Control System* 2. Simultaneously press and hold both the3.Firmly press, hold for five seconds and6.Return to the vehicle and firmly press, chosen HomeLink and hand-held trans-release the programmed HomeLink but-hold for two seconds and release the pro- mitter buttons until the HomeLink indica-ton up to two separate times to activategrammed HomeLink button. Repeat the tor light changes from a slow to a rapidlythe door. If the door does not activate,“press/hold/release” sequence a second blinking light. Now you may release bothpress and hold the just-trained HomeLinktime, and, depending on the brand of the the HomeLink and hand-held transmitterbutton and observe the indicator light.garage door opener (or other rolling code buttons. equipped device), repeat this sequence a 03 • If the indicator light stays on con- third time to complete the programming stantly, programming is complete process. NOTE and your device should activate when the HomeLink button is pressed and HomeLink should now activate your rolling Some devices may require you to replace released. this Programming Step 2 with procedures code equipped device. noted in the “Gate Operator / Canadian • If the indicator light blinks rapidly for Programming” section. If the HomeLink Gate Operator/Canadian Programming two seconds and then turns to a indicator light does not change to a rapidly Canadian radio-frequency laws require trans- constant light continue with “Pro- blinking light after performing these steps, mitter signals to “time-out” (or quit) after sev- gramming” steps 4-6 to complete the contact HomeLink at www.homelink.com eral seconds of transmission – which may not programming of a rolling code equip- or by phoning the hotline at be long enough for HomeLink to pick up the ped device (most commonly a garage 1–800–355–3515. door opener). signal during programming. Similar to this Canadian law, some U.S. gate operators are 4. At the garage door opener receiver designed to “time-out” in the same manner. (motor-head unit) in the garage, locate the “learn” or “smart” button. This canIf you live in Canada or you are having diffi- usually be found where the hangingculties programming a gate operator or antenna wire is attached to the motor-garage door opener by using the “Program- head unit. ming” procedures, replace “Programming HomeLink” step 2 with the following: 5. Firmly press and release the “learn” or “smart” button. (The name and color of• Continue to press and hold the HomeLink button while you press and release - the button may vary by manufacturer.) every two seconds (“cycle”) your hand- There are 30 seconds to initiate step 6. held transmitter until the HomeLink indi- cator light changes from a slow to a rap- idly blinking light. Now you may release 118 * Option/accessory, for more information, see Introduction.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders