owners manual Hyundai Genesis

all ratings: 0 average rating: 5

Convenient features of your vehicle Flashing ✽✽ NOTICE 5. At the garage door opener receiv- er (motor-head unit) in the garage, Some devices may require you to locate the "learn" or "smart" but- replace this Programming step 3 ton. This can usually be found with procedures noted in the "Gate Operator/Canadian Programming" where the hanging antenna wire is chapter. If the HomeLink ® indicatorattached to the motor-head unit. 6. Firmly press and release the light does not change to a rapidly blinking light after performing these"learn" or "smart" button. (The ® name and color of the button vary steps, contact HomeLinkat www.homelink.com. by manufacturer). There are 30 seconds to initiate step 7. ODH044414N 4. Firmly press, hold for 5 seconds and7. Return to the vehicle and firmly release the programmed 2. Position the end of your hand-heldHomeLink ® button up to two sepa-press, hold for 2 seconds and transmitter 1-3 inches (2-8 cm) release the programmed ® rate times to activate the door. If the ® button. Repeat the away from the HomeLinkbutton HomeLink door does not activate, press and you wish to program while keepinghold the just-trained HomeLink®but-"press/hold/release" sequence a the indicator light in view. ton and observe the indicator light.second time, and, depending on 3. Simultaneously press and hold the brand of the garage door ® • If the indicator light stays on con-opener (or other rolling code both the HomeLinkand hand- stantly, programming is completeequipped device), repeat this held transmitter buttons until the and your device should activate HomeLink®indicator light changes sequence a third time to complete ® when the HomeLinkbutton is the programming process. from a slow to a rapid blinking pressed and released. light. Now you may release both ® • If the indicator light blinks rapidly ® the HomeLinkand hand-held HomeLink should now activate your transmitter buttons. for 2 seconds and then turns to arolling code equipped device. constant light, continue with "Programming" steps 5-7 to com- plete the programming of a rolling code equipped device (most com- monly a garage door opener). 3-26

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders