owners manual Saab 9-5

all ratings: 0 average rating: 5

95_US_MY09.book Page 120 Tuesday, April 15, 2008 11:03 AM 120 Interior equipment and trunk Gate Operator / Ca nadian Programming Erasing the three buttons Canadian radio-frequency laws require NOTICE To erase programming from the three but- transmitter signals to "time-out" (or quit) tons (individual buttons cannot be erased after several second s of transmission - Switch off the power supply to the garage but can be "reprogrammed" as outlined which may not be long enough for the door or gate (or park the car beyond the below), follow the step noted: garage opener to pick up the signal during range of the remote control) while pro-• Press and hold the two outer buttons until programming. Similar to this Canadian law, gramming using the "cycling" method to the indicator light begins to flash-after some U.S. gate operators are designed to prevent damaging the electrical motor.20 seconds. Release both buttons. Do "time-out" in the same manner. not hold for longer that 30 seconds. The If you live in Canada or you are having diffi-Reprogramming a single buttongarage opener is now in the train (or culties programming a gate operator by To program a device to the garage opener learning) mode and can be programmed using the "Programming" procedures using a button previously trained, follow at any time beginning with "Programming" (regardless of where you live), replace these steps: - step 3. "Programming " step 4 with the following:1 Press and hold the desired button. DO Note: If programming a garage door opener NOT release the button. or gate operator, it is advised to unplug the 2 The indicator light will begin to flash after device during the "cycling" process to pre-20 seconds. Without releasing the vent possible overheating. button, proceed with "Programming" - Continue to press and hold the button while step 3. you press and release - every two sec- onds ("cycle") your hand-held transmitter until the frequency signal has successfully been accepted by the garage opener. (The indicator light will flash slowly and then rap- idly.) Proceed with "Programming" step five to complete.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders