BMW X5 X6 E71 E72 owners manual page 118

text version of content this owner's manual page from owners manual to the vehicle BMW X5 X6 E71 E72, year of production 2008 - 2014:

ba8_e70ag.book Seite 116 Freitag, 5. Juni 2009 11:42 11 The corresponding memory button1 is now The corresponding memory button1 is now programmed with the signal of the original programmed with the signal of the original hand-held transmitter. hand-held transmitter. You can operate the device when the engine is Should you have questions, please con- running or when the ignition is switched on.tact your BMW Sports Activity Vehicle If the device cannot be used after Center.< repeated programming, check whether Deleting all stored programs the original hand-held transmitter uses an alter- nating-code system. To do so, either read the Press the left and right-hand memory button1 instructions for the original hand-held transmit-for approx. 20 seconds until the LED2 flashes ter or hold down the programmed memory but-quickly: ton 1 of the integrated universal remote control. All stored programs are deleted. If the LED 2 on the integrated universal remote control flashes rapidly for a short time and then Reassigning individual programs remains lit for approx. 2 seconds, this indicates 1.Hold the original hand-held transmitter at that the original hand-held transmitter uses an adistance of approx. 4 in/10 cm to 12in/ alternating-code system. In the case of an alter-30cm from the memory buttons1. nating-code system, program the memory but-The required distance between the tons 1 as described at Alternating-code hand-hand-held transmitter and the mem- held transmitters.< ory buttons1 depends on the relevant sys- Alternating-code hand-held tem of the original hand-held transmitter transmitters used.< Practical interior accessories 2.Press the desired memory button1 ofthe To program the integrated universal remote integrated universal remote control. control, consult the operating instructions for the equipment to be set. You will find informa-3.When the LED 2 flashes slowly after approx. tion there on the possibilities for synchroniza-20seconds, press the transmit button of tion. the original hand-held transmitter. Release When programming hand-held transmitters both buttons as soon as the LED2 flashes that employ an alternating code, observe the rapidly. If the LED 2 does not flash rapidly following supplementary instructions:after approx. 15 seconds, alter the distance Programming will be easier with the aid of and repeat the step. a second person.< 1.Park your vehicle within the range of the Digital compass* remote-controlled device. 2.Program the integrated universal remote control as described above in the section Fixed-code hand-held transmitters. 3.Locate the button on the receiver of the device to be set, e.g. on the drive unit. 4.Press the button on the receiver of the device to be set. After step 4, you have approx. 30 seconds for step 5. 5.Press the programmed memory button1 1 Adjustment button of the integrated universal remote control three times. 2 Display 116 Online Edition for Part no. 01 41 2 602 756 - © 06/09 BMW AG

owners manual BMW X5 X6 E71 E72

owners manual BMW X5 X6 E71 E72 - year of production: 2008, 2009, 2010, 2011, 2012, 2013, 2014 - BMW X5 X6 E71 E72 owners manual EN