Nissan Patrol Y61 GR owners manual page 118

text version of content this owner's manual page from owners manual to the vehicle Nissan Patrol, year of production 1997:

JUMP ARTIST NG PUSH ST ARTI NG about 2,000 rpm, and start your engine in hous or more or dr iven less than 1. 6 km (1 at CAUT ION: wheel nuts with your fingers. Check that all Di esel engine with man ual the normal manner. mi le). Vehicle being the wheel nuts contact the wheel surface • Automatic transmission models cannot transmission (except ZD30DD Ti jump started horizontally. r starting your engine, disco n COLD tir e pressures are shown on the tire 4. Afte carefu lly be stated by pushing. This may cause engine models) nect the negative cable and positiv e placard affixed to the gl ove box lid or then the transmission damage. 3. Tighten the wheel nuts alternately and evenly 1. Turn the ign ition switch to the OFF (not cable. driver side center pill ar. in the sequence ill ustrated (D - @), more • Th ree way cataly st or oxidation cataly st LOCK) position. than 2 times with the wheel nut wrench, until 5. Replace the vent caps (If so equi pped ). equipped models should not be stated A WARN ING: 2. Hold the clutch pedal fully depr essed and they are tight. by pushing since the cataly sts may be shift into second or third gear. Place the Retighten the wheel nuts when the vehicle da maged. 4. Lower the vehicle slowly until the tire touches has been driven for 1, 000 km (600 mile s) transfer shift lever in 2H and free-ru nning the ground. • Never ty to start the vehicle by towtng (also hubs (if so equipped) in the AUTO or FREE in cases of a flat ti re, etc.). it; when the engine stats, the foward position . 5. Tighten the wheel nuts securely, with the STOWING THE DAMAG ED TIRE surge could cause the vehicle to collide wheel nut wrench, in the sequence illus 3. Hold the accelerator pedal fully depressed. AND TOOL S SCE 0216 with the tow vehicle. trated. 4. Start pushing, and when the vehicle reaches Securely store the spare tire and jacking equip Gas oline engine with manual CAUT ION: 6. Lower the vehicle completely. a speed of about 16 km/h (1 0 MP H), turn the ment in the vehicle. transmission (except thr ee way Use a battey rated at 12 volts for a ignition key to ON and slowly release the Tighten the wheel nuts to the specified catalyst equip ped mode ls) A WA RNIN G: clutch pedal to start the engine. booster. torque with a torque wrench as soon as 1. Turn the ignition switch to ON. pos sible. Always make sur e that the spare tire and 1. Remove vent caps on the battery (If so jacking equipm ent are properly secured 2. Hold the clutch pedal fully depressed and equi pped). Cover the battery with an old Wheel nut tightening tor que: after use. Such items can become danger sh ift into second or third gear. Place the cloth as shown. 13 3 N·m (14 kg-m, 98 ft-Ib) ous projectiles in a serious accident. transfer shift lever in 2H and free-r unning 2. Connect jumper cables in the sequence as The wheel nuts mus t be kept tightened to hubs (if so equip ped) in the AUTO or FREE ill ustrated. specification at all times. It is reco m position. mended that the wheel nuts be tightened CAUTI ON: 3. Hold the accelerator pedal about half way. to specification at each lubr ication interval. e An in correct conn ction could result in 4. Start pushing, and when the vehicle reaches Adjust tire pres sur e .to the·COLD pressure. damage to the charging syste m. a speed of about 16 km/h (1 0 MPH), slowly release the clutch pedal to start the . engine COLD pres sure: 3. Start the engine of the other vehicle and let it run for a few minutes. Keep the engine speed Afte r vehicle has been parked for three 6-8 In case of emergency In case of emergency 6-9

owners manual Nissan Patrol

owners manual Nissan Patrol - year of production: 1997 - Nissan Patrol Y61 GR owners manual EN