owners manual Nissan Altima

all ratings: 0 average rating: 5

PROGRAMMINGHOMELINKTFOR PROGRAMMINGTROUBLE- CLEARINGTHEPROGRAMMED CANADIANCUSTOMERS DIAGNOSIS INFORMATION Prior to 1992, D.O.C. regulations required hand-If the HomeLinkTdoesnotquicklylearnthehand-Individual buttons cannot be cleared. However, heldtransmitters to stop transmitting after 2 sec-held transmitter information:to clear all programming, press and hold the two onds. To program your hand-held transmitter to● replace the hand-held transmitter batteriesoutside buttons and release when the indicator HomeLinkT, continue to press and hold thewith new batteries.light begins to flash (approximately 20 seconds). HomeLinkTbutton (note steps2-4under “Pro- ROLLINGCODEPROGRAMMING gramming HomeLinkT”) while you press and re-● position the hand-held transmitter with its press(“cycle”) your hand-held transmitters everybatteryareafacingawayfromtheRolling code garage door openers (or other roll- 2secondsuntil the indicator light flashes rapidlyHomeLinkT surface.ing code devices) which are “code protected” (indicating successful programming).● press and hold both the HomeLinkT andand manufactured after 1996, may be deter- NOTE: hand-held transmitter buttons without inter-mined by the following: ruption. ● ReferencethegaragedooropenerOwner’s Whenprogrammingagaragedooropener, Manual for verification. etc., it is advised to unplug the device dur-● position the hand-held transmitter1-3 ing the “cycling” process to prevent pos-inches (26 - 76 mm) away from the● The hand-held transmitter appears to pro- sible damage to the garage door openerHomeLinkT surface. Hold the transmitter ingram the HomeLinkT Universal Transceiver components. that position for up to 15 seconds. Ifbut does not activate the garage door. HomeLinkT is not programmed within that OPERATINGTHEHOMELINKT time, try holding the transmitter in another● Press and hold the trained HomeLinkT but- UNIVERSALTRANSCEIVER position – keeping the indicator light in viewton. If the garage door opener has the rolling at all times. code feature, the HomeLinkT indicator light TheHomeLinkTUniversalTransceiver(oncepro-If you continue to have programming difficulties,will flash rapidly, then remains on after 2 grammed) may now be used to activate the ga-please contact the NISSAN Consumer Affairsseconds. rage door, etc. To operate, simply press the ap-Department. The phone numbers are located inToprogramtheHomeLinkTUniversalTransceiver propriate programmed HomeLinkT Universalthe Foreword of this manual.to a garage door opener with the rolling code Transceiver button. The red indicator light will feature,followtheseinstructionsaftercompleting illuminate while the signal is being transmitted. the “Programming HomeLink” (the aid of a sec- ond person may make the following procedures quicker and easier). Instruments and controls 2-49 ZREVIEWCOPY—2007Altima (alt) Owners Manual—USA_English (nna) 10/26/06—debbieX

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders