Nissan Rogue I 1 owners manual page 115

text version of content this owner's manual page from owners manual to the vehicle Nissan Rogue, year of production 2007 - 2013:

Black plate (115,1) to three times to complete the training. the “cycling” process to prevent possible programmed within that time, try holding the ® damage to the garage door opener com- transmitter in another position - keeping the 8. Your HomeLink button should now be ponents. indicator light in view at all times. programmed. To program the remaining HomeLink® buttons for additional door or OPERATINGTHE HomeLink® UNIVER- If you continue to have programming difficulties, gate openers, follow steps 2 through 8 only. SALTRANSCEIVER please contact the NISSAN Consumer Affairs Department. The phone numbers are located in NOTE: HomeLink® Universal Transceiver (once pro- the Foreword of this Owner’s Manual. Do not repeat step 1 unless you want to grammed) may now be used to activate the “clear” all previously programmed Home- garage door, etc. To operate, simply push the CLEARINGTHE PROGRAMMED IN- Link® buttons. appropriate programmed HomeLink® Universal FORMATION If you have any questions or are having difficultyTransceiver button. The red indicator light will Individual buttons cannot be cleared, however to programming your HomeLink® buttons, please illuminate while the signal is being transmitted. clear all programming, push and hold the two refer to the HomeLink® web site at: www. PROGRAMMINGTROUBLE-DIAGNO- outside buttons and release when the indicator homelink.com or call 1-800-355-3515. SIS light begins to flash (in approximately 20 seconds). PROGRAMMINGHomeLink® FOR CA- If HomeLink® does not quickly learn the hand- NADIAN CUSTOMERS held transmitter information: REPROGRAMMINGASINGLE HomeLink® BUTTON Prior to 1992, D.O.C. regulations required . replace the hand-held transmitter batteries hand-held transmitters to stop transmitting after with new batteries. To reprogram a HomeLink® Universal Transcei- 2 seconds. To program your hand-held trans- . position the hand-held transmitter with its ver button, complete the following. ® mitter to HomeLink , continue to push and hold ® the HomeLink® button (note steps 2 through 4 battery area facing away from the Home- 1.PushandholdthedesiredHomeLink Link® surface. button. Do not release the button until step under “Programming HomeLink®”) while you push and re-push (“cycle”) your hand-held . push and hold both the HomeLink® and 4 has been completed. transmitter every 2 seconds until the indicator hand-held transmitter buttons without inter- 2. When the indicator light begins to flash light flashes rapidly (indicating successful pro- ruption. slowly (after 20 seconds), position the gramming). hand-held transmitter 2 to 5 in (50 to 127 . position the hand-held transmitter 2 to 5 in mm) away from the HomeLink® surface. NOTE: (50 to 127 mm) away from the HomeLink® If programming agaragedooropener,etc., surface. Hold the transmitter in that position3. Push and hold the hand-held transmitter it is advised to unplug the device during for up to 15 seconds. If HomeLink® is not button. Instruments and controls 2-49 Model "S35-D" EDITED: 2007/ 12/ 19

owners manual Nissan Rogue

owners manual Nissan Rogue - year of production: 2007, 2008, 2009, 2010, 2011, 2012, 2013 - Nissan Rogue I 1 owners manual EN