Chevrolet Astro II 2 owners manual page 109

text version of content this owner's manual page from owners manual to the vehicle Chevrolet Astro, year of production 1995 - 2005:

2. Position the end of your hand-held transmitter If the indicator light blinks rapidly for two seconds about 1 to 3 inches (3 to 8 cm) away from the and then turns to a constant light, continue with HomeLink® buttons while keeping the indicator Steps 6 through 8 following to complete the light in view. programming of a rolling-code equipped device 3. Simultaneously press and hold both the desired (most commonly, a garage door opener). button on HomeLink® and the hand-held transmitter 6. Locate in the garage, the garage door opener button. Do not release the buttons until Step 4 receiver (motor-head unit). Locate the “Learn” has been completed. or “Smart” button. This can usually be found where Some entry gates and garage door openers may the hanging antenna wire is attached to the require you to substitute Step 3 with the procedure motor-head unit. noted in “Gate Operator and Canadian 7. Firmly press and release the “Learn” or “Smart” Programming” later in this section. button. The name and color of the button may 4. The indicator light will ﬂash slowly at ﬁrst and then vary by manufacturer. rapidly after HomeLink® successfully receives the You will have 30 seconds to start Step 8. frequency signal from the hand-held transmitter. 8. Return to the vehicle. Firmly press and hold the Release both buttons. ® programmed HomeLink button for two seconds, 5. Press and hold the newly-trained HomeLink® button then release. Repeat the press/hold/release and observe the indicator light. sequence a second time, and depending on the If the indicator light stays on constantly, brand of the garage door opener (or other rolling programming is complete and your device should code device), repeat this sequence a third time activate when the HomeLink® button is pressed and to complete the programming. ® released. HomeLink should now activate your rolling-code To program the remaining two HomeLink® buttons, equipped device. begin with Step 2 under “Programming HomeLink®.” ® To program the remaining two HomeLink buttons, Do not repeat Step 1 as this will erase all of the ® programmed channels. begin with Step 2 of “Programming HomeLink .” You do not want to repeat step 1, as this will erase all previous programming. 2-31

owners manual Chevrolet Astro

owners manual Chevrolet Astro - year of production: 1995, 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005 - Chevrolet Astro II 2 owners manual EN