BMW M5 E60 M Power owners manual page 108

text version of content this owner's manual page from owners manual to the vehicle BMW M5 E60, year of production 2005 - 2010:

You can operate the device when the engine is If you have any additional questions, running or when the ignition is switched on.please contact your BMW center.< If the device fails to function even after Deleting all stored programs repeated programming, check whether the original hand-held transmitter uses an alter-Press the left and right-hand memory button1 nating-code system. To do so, either read the for approx. 20 seconds until the LED2 flashes instructions for the original hand-held transmit-quickly: ter or hold down the programmed memory All stored programs are deleted. button1 of the integrated universal remote Individual programs cannot be deleted. control. If the LED 2 on the integrated universal remote control flashes rapidly for a short time Rememorizing individual programs and then remains lit for approx. 2 seconds, this 1.Hold the original handheld remote control indicates that the original hand-held transmitter approx. 4 in/10 cm to 12 in/30 cm away uses an alternating-code system. In the case of from the memory buttons1. an alternating-code system, program the mem- ory buttons 1 as described at Alternating-code The required distance between the hand-held transmitters.< hand-held transmitter and the mem- ory buttons1 depends on the relevant sys- Alternating-code hand-held tem of the original hand-held transmitter transmitters used.< To program the integrated universal remote 2.Press the desired memory button1 of the control, consult the operating instructions for integrated universal remote. the equipment to be set. You will find informa-3.If the LED 2 flashes slowly after approx. Practical interior accessories tion there on the possibilities for synchroniza-20seconds, press the command button of tion. the original hand-held transmitter. As soon When programming hand-held transmitters as the LED2 flashes rapidly, release both that employ an alternating code, please observe buttons. If the LED2 does not flash rapidly the following supplementary instructions:after approx. 15 seconds, alter the distance Programming will be easier with the aid of and repeat the step. a second person.< 1.Park your vehicle within the range of the Sun blinds* remote-controlled device. 2.Program the integrated universal remote Sun blind for rear window control as described above in the section Fixed-code hand-held transmitters. 3.Locate the button on the receiver of the device to be set, e.g. on the drive unit. 4.Press the button on the receiver of the device to be set. After step 4, you have approx. 30 seconds for step 5. 5.Press the programmed memory button1 of the integrated universal remote control three times. Press the button on the driver's door. The corresponding memory button1 is now programmed with the signal of the original hand-held transmitter. 106 Online Edition for Part no. 01 41 2 600 738 - © 08/08 BMW AG

owners manual BMW M5 E60

owners manual BMW M5 E60 - year of production: 2005, 2006, 2007, 2008, 2009, 2010 - BMW M5 E60 M Power owners manual EN