owners manual Subaru Forester

all ratings: 0 average rating: 5

2-16 Keys and doors 2. Turn the ignition switch from “ON” to Disarming the system Shock sensors (dealer op- “LOCK” position and remove the key from To disarm the system, briefly press the tion) the ignition switch. “ ” button on the transmitter. The shock sensors trigger the alarm sys- Tripped sensor identification tem when they sense impacts applied to the vehicle and when any of their electric The security indicator light flashes whenwires is cut. The alarm system causes the the alarm system has been triggered. Al-horn to sound and the turn signal lights to so, the number of flashes indicates the lo-flash for a short time when the sensed im- cation of unauthorized intrusion or the se-pact is weak, but it warns of a strong im- verity of impact on the vehicle. pact or multiple impacts by sounding the When the ignition switch is turned to thehorn and flashing the turn signal lights, “ON” position, the indicator light will lightboth lasting approximately 30 seconds. for 1 second and then flash as follows: If you desire, your SUBARU dealer can When a door or rear gate was opened: connect them and set them for activation 200817 5 times or deactivation. 3. Open the doors and get out of the vehi-When the ignition switch was turned toNOTE cle. the “ON” position: 3 times The shock sensors are not always 4. Before closing the doors, lock all doorsWhen a strong impact or multiple im- able to sense impacts caused by with the inside door lock levers. pacts were sensed: twice (only vehiclesbreaking in, and cannot sense an im- 5. Close the doors. The system will auto- with shock sensors (dealer option)) pact that does not cause vibration matically arm after one minute. When a light impact was sensed: once (such as breaking the glass using a (only vehicles with shock sensors (deal-rescue hammer). In the passive mode, the system can also er option)) The shock sensors may sense vibra- be armed with the remote transmitter or NOTE tion like those shown below and trigger with the power door locking switches. IfAny of the above indicator light flash- the alarm system. Select the settings of the remote transmitter or power door lock-ings will recur each time the ignitionthe alarm system and shock sensors ing switch is used to lock the vehicle, arm-switch is turned to the “ON” position.appropriately depending on where you ing will take place immediately regardlessRearming the alarm system cancels usually park your vehicle. of whether or not the passive mode has the flashing. Example: been selected. Vibration from a construction site Vibration in a multistory parking ga-

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders