owners manual Subaru Outback

all ratings: 0 average rating: 5

Keys and doors 2-15 four transmitter codes into the system. IfAlarm system The alarm is triggered by: you have only one current transmitter, . Opening a door, the rear gate or trunk program it four times. If you have twoThe alarm system helps to protect yourlid current transmitters, program each onevehicle and valuables from theft. The horn. Physical impact to the vehicle, such as twice. If you have three current transmit-sounds and the turn signal lights flash ifforced entry (only vehicles with shock ters, program two of them once and thesomeone attempts to break into your sensors (dealer option)) third one twice. This process will leavevehicle. only current transmitter codes in the &Activating and deactivating system’s memory. The system can be armed and disarmedthe alarm system with the remote transmitter. NOTE The system does not operate when theTo change the setting of your vehicle’s Make sure no one else is operatingkey is inserted into the ignition switch.alarm system for activation or deactiva- their keyless entry system within range tion, do the following. of your vehicle when programming Your vehicle’s alarm system has been set1. Disarm the alarm system (refer to transmitters. If someone else were tofor activation at the time of shipment from“Disarming the system” in this section). operate their remote transmitter whilethe factory. You can set the system for2. Sit in the driver’s seat and shut all you are programming your transmit-deactivation yourself or have it done bydoors(andthereargateifyourvehicleisa ters, it is possible that their transmitteryour SUBARU dealer.Station wagon). code will be programmed into your&Systemalarm operation 3. Turn the ignition switch to the “ON” system, allowing them unauthorized position. access to your vehicle. The alarm system will give the following4. Hold down the UNLOCK side of the alarms when triggered: driver’s power door locking switch, open . The vehicle’s horn will sound and thethe driver’s door within the following 1 turn signal lights will flash for 30 seconds.second, and wait 10 seconds without . If any door (or the rear gate/trunk lid)releasing the switch. The setting will then remains open after the 30-second period,be changed as follows: the horn will continue to sound for a maximum of 3 minutes. If the door (orIf the system was previously activated: the rear gate/trunk lid) is closed while theFor a vehicle without SI-DRIVE, the horn is sounding, the horn will stop odometer/trip meter screen displays “AL soundingwithadelayofupto30seconds.oF”, and for a vehicle with SI-DRIVE, the multi-information display shows “Security – CONTINUED –

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders