owners manual Mercedes E

all ratings: 0 average rating: 5

212_AKB; 2; 41, en-US 2009-07-17T09:14:21+02:00 - Seite 101 d2ureepe, Version: 2.11.8.1 Lighting 101 When driving faster than approximately Warning! G 34 mph (55 km/h) and no other road users The Adaptive Highbeam Assist is only an aid are recognized, the high-beam headlamps intended to support you while driving. The are switched on automatically. The high- driver is and remains responsible for proper beam headlamp indicator lamp K in the vehicle lighting in accordance with the instrument cluster comes on additionally. prevailing light, sight and traffic conditions. When driving slower than approximately The system may be impaired or unavailable 28 mph (45 km/h), other road users are when recognized, or the road is illuminated R visibility is poor, e.g. due to snow, rain, fog, sufficiently, the high-beam headlamps are or heavy spray switched off automatically. The indicator lamp K in the instrument cluster goes R the optical sensor area of the windshield is out. The Adaptive Highbeam Assist dirty, fogged up, or covered by a sticker for indicator _ in the multifunction display example remains on. The system cannot recognize the following Adaptive control of the headlamp leveling road users: Controls in detail takes place at a speed of approximately R Road users without a lighting system of 25 mph (40 km/h). their own, e.g. pedestrians XDeactivating: Pull the combination switch R Road users with dim lighting of their own,back to its initial position. e.g. cyclists The Adaptive Highbeam Assist indicator _ in the multifunction display R Road users whose lighting is obstructed, goes out. e.g. road users behind a guardrail R In some seldom cases, even road users with High-beam flasher a lighting system of their own may be recognized too late or not at all.X Switching on: Pull the combination switch briefly in direction of arrow =. The automatic high-beam headlamps will then not be deactivated or it will be activated in spite of preceding or oncoming road users. Hazard warning flasher This could endanger you and/or others and cause an accident. Always pay close attention The hazard warning flasher can be switched to the traffic situation and switch off the high on at all times, even with the SmartKey beam manually if necessary. removed from the starter switch. The hazard warning flasher comes on XActivating: Enable the Adaptive automatically when an air bag deploys. Highbeam Assist via the control system (Y page 142). XTurn the exterior lamp switch to position c. XPress the combination switch in direction of arrow :. The Adaptive Highbeam Assist indicator _ in the multifunction display comes on when switching on the low-beam headlamps. Z

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders