owners manual Volvo XC90

all ratings: 0 average rating: 5

INSTRUMENTS AND CONTROLS 4. ® || Press the programmed HomeLink button Gate Operator/Canadian Programming and check the indicator light. Canadian radio-frequency laws require transmit- Indicator light glows steadily green: pro- ter signals to “time-out” (or quit) after several gramming has been completed. The garage seconds of transmission – which may not be long door, gate, etc., should now be activated enough for HomeLink to pick up the signal dur- when the programmed button is pressed. ing programming. Similar to this Canadian law, some U.S. gate operators are designed to “time- Indicator light flashes 10 times a second: out” in the same manner. ® press the HomeLink button that is being If you live in Canada or you are having difficulties programmed. Hold it for 2 seconds and programming a gate operator or garage door release it. Repeat the “press/hold/release” 5. Locate the "training" button on the garage sequence a second time, and, depending on door opener, etc. The designation and color opener by using the “Programming” procedures, the brand of the garage door opener, repeat of the button may vary, depending on the replace “Programming HomeLink” step 3 this sequence a third time to complete the manufacturer. It is usually located near the with the following: antenna attachment on the device. Continue to press and hold the HomeLink programming process. Programming should • now be completed and the garage door, 6. Press the device€s "training" button. When button while you press and release - every gate, etc., should now be activated when the this has been done, step 8 must be comple- two seconds (“cycle”) your hand-held trans- programmed button is pressed. ted within 30 seconds. mitter until the HomeLink indicator light changes from a slow to a rapidly blinking If the garage door, etc. still does not 7. Press and hold the HomeLink® button being light. Now you may release both the Home- react: continue with steps 6-8 to complete programmed for 2 seconds and release it. Link and hand-held transmitter buttons. programming. Repeat the “press/hold/release” sequence a second time, and, depending on the brand of Proceed with “Programming” step 4 to complete. the garage door opener, repeat this Using HomeLink® sequence a third time to complete the pro- When programming has been completed, gramming process. Programming should now ® be completed and the garage door, gate, etc., HomeLink can be used instead of the original should now be activated when the pro- remote controls. grammed button is pressed. To operate, press and hold the programmed ® HomeLink button until the trained device begins 3 to operate (this may take several seconds). The 3 Do not hold the button for more than 20 seconds as this will clear the programming of the button. 100

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders