owners manual Subaru Forester

all ratings: 0 average rating: 5

2-12 Keys and doors tered the second time is identical to thatfour transmitter codes into the system. IfAlarm system entered the first time. you have only one current transmitter, NOTE program it four times. If you have two cur-The alarm system helps to protect your If the code entered the second time isrent transmitters, program each one twice.vehicle and valuables from theft. The horn not identical to the code entered theIf you have three current transmitters, pro-sounds and the turn signal lights flash if first time, an error will occur. In thisgram two of them once and the third onesomeone attempts to break into your vehi- event, perform the procedure again be-twice. This process will leave only currentcle. The starter motor is also interrupted to ginning with part 5. If an error occurstransmitter codes in the system’s memory.prevent starting the vehicle without a key. five times, perform the procedureNOTE The system can be armed and disarmed again starting with part 3.Make sure no one else is operatingwith the remote transmitter. 10.If you wish to program another trans-their keyless entry system within rangeThe system does not operate when the mitter code into the system (up to fourof your vehicle when programmingkey is inserted into the ignition switch. transmitter codes can be programmedtransmitters. If someone else were toYour vehicle’s alarm system has been set into the system), perform the procedureoperate their remote transmitter whilefor activation at the time of shipment from beginning with part 4. When you have fin-you are programming your transmit-the factory. You can set the system for de- ished programming all of the necessaryters, it is possible that their transmitteractivation yourself or have it done by your transmitter codes into the system, removecode will be programmed into yourSUBARU dealer. the key from the ignition switch.system, allowing them unauthorized 11.Test every registered transmitter toaccess to your vehicle.System operation confirm correct operation. The alarm system will give the following Deleting old transmitter codes alarm when triggered: The control unit of the keyless entry sys- The vehicle’s horn will sound and the tem has four memory locations to store turn signal lights will flash for 30 seconds. transmitter codes, giving it the ability to If any door or the rear gate remains operate with up to four transmitters. When open after the 30-second period, the horn you lose a transmitter, the lost transmit- will continue to sound for a maximum of 3 ter’s code remains in the memory. For se- minutes. If the door and the rear gate are curity reasons, lost transmitter codes closed while the horn is sounding, the should be deleted from the memory. horn will stop sounding with a delay of up To delete old transmitter codes, program to 30 seconds.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders